Simple woodworking

Butt joints are the easiest way to join two pieces of wood, and even if it is not the strongest of the joints, it is very useful in some situations, and it is a simple technique for woodworking. There are certain methods that should be noted to ensure that your butt joints are as safe as possible.

A butt joint is when a piece of surplus stock to another and secured with glue. Common strengthened in general, with screws or nails. "

Square cuts are symbols:

The key to a good quality butt is to ensure that the ends are cut off the two plates are as real as possible, thus ensuring a good contact. This is done most easily using a Miter saw not, but good results can be achieved with a circular saw and a square format, provided that the angle of the blade of the saw is set at zero degrees.

Provides Glue Strength:

Strength and durability of a butt joint comes out of the glue joint. Yet there are two problems with employing glue as the sole means of joint efforts.

First of all, if glue is used, the end grain, tending to the forest, soaking more than glue on the side of the grain used. End grain is the porous part of the wood, so you might need a little more glue as you apply a rule.

Second, the adhesive does not offer much in the way of the lateral force. For this reason it is advisable to use a few screws to reinforce the joint.

If you are made of hardwood for your project, you need to drill pilot holes before you screw in the joint or you will be the share split and ends with a bigger problem on your hands, but a weak joint.

There are many ways to connect two pieces of wood, and contains some of these possibilities already well advanced wood technology. The butt joint is a very simple single and can fully satisfactory in certain circumstances.